User Manual

12
AudioAce™ Portable Bluetooth
®
CD Player
Listening to CDs
Insert a CD:
1. Open the CD door by pressing the Open button.
2. Insert a disc into the disc compartment with the title side up.
3. Close the CD compartment door.
Removing a CD:
Press the Stop/M+ button once, open the CD door by pressing Open
button. Remove the CD when it has stopped spinning.
Playing a CD:
1. Press the Source button to select CD mode.
2. Insert CD into player, “---” will appear for a few seconds, and the total
track/ file number will appear on the display and the CD will
automatically start playing.
3. Pres /Tune+ or /Tune- button to jump to next/previous
track playing.
4. Press and hold the /Tune+ or /Tune- button to fast forward/
rewind the track playing.
5. Press the Play/Pause/Pair button to pause the CD playing. Press
again to resume play.
6. Press the Stop/M+ button to stop the CD playing.
7. After all tracks have been played, the CD player will stop automatically.
Programming CD Tracks:
You can preset up to 20 program tracks for easy access. “FU” will appear
on the LCD display when 20 tracks have been programmed.
1. Make sure the CD is not running by pressing the Stop/M+ button.
2. Press the MEM/PROG button once, and “P01” will blink on the LCD
display, then “00” will appear on the LCD display.
3. Press the /Tune+ or /Tune- button until the display shows the
desired track number.
4. Press the MEM/PROG button to store the selection
5. Repeat steps 3-4 to store additional tracks.
6. Once the last desired track is programmed, press the MEM/PROG
button to complete the programming process.
7. To play the stored sequence, press the Play/Pause/Pair button.
8. To cancel program, press the Stop/M+ button twice.
9. After all memory tracks have been played, the player will stop
automatically.