READ BEFORE USE The Scoop 2-Way Brewer Visit www.hamiltonbeach.in for our complete line of products and Use and Care Guides – as well as delicious recipes, tips, and other helpful information! Questions? Please call us – our friendly associates are ready to help. 1.800.42.555.
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following: 1. Read all instructions. 2. This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices, and other working environments; farm houses; by clients in hotels, motels, and other residential type environments; bed and breakfast-type environments. 3.
Single-Serve Side Parts and Features Single-Serve Side Reservoir Carafe Side Parts and Features Carafe Side Reservoir Permanent Coffee Filter Brew Basket Scoop Brew Basket Filter Basket Control Panel and Display Travel Lid Travel Mug Cord-Stuff Storage Keep-Hot Plate Drip Tray Multilevel Cup Rest Carafe 3
How to Use Single-Serve Side WARNING Burn Hazard. To avoid contact with hot coffee or water: • Do not use more than 14 ounces (410 ml) of water. • Fill single-serve reservoir with mug or cup into which the coffee will be brewed. • Fully insert mug or cup under filter basket. AUTOMATIC SHUTOFF: The coffeemaker will automatically shut off after brew cycle is complete. NOTES: • The unit will only brew on one side at a time.
How to Use Single-Serve Side (cont.) MAX FILL LINE MIN FILL LINE INCORRECT REGULAR MUG 6 7A-1 – GROUNDS For regular coffee, use a maximum of two level tablespoons of grounds. To avoid overflow, use slightly less grounds when brewing decaf or flavored coffees. WARNING! Keep ground coffee below MAX fill line to prevent overflow. 7A-2 – GROUNDS Single-serve brew basket has two markings: the lower level marking if making 8 oz. (250 ml) of coffee, and the higher level mark if making 14 oz.
How to Use Single-Serve Side (cont.) 8 9 Press I/O (ON/OFF) button to begin the flow of coffee. Coffeemaker will shut off when brew cycle is complete. To stop flow of coffee midcycle, press I/O (ON/OFF) button.
How to Use Carafe Side 1 2 AUTOMATIC SHUTOFF: The coffeemaker will automatically shut off 2 hours after brew cycle is complete. NOTE: The unit will only brew on one side at a time. 3 5 Place carafe, with carafe lid attached, on keep-hot plate. 6 4 Lift lid and pour water from carafe into reservoir. NOTE: Do not fill past the 12-cup mark (60 ounces [1.8 L]). Push lever right to select Carafe. 7 Place a permanent filter in brew basket. A cupcake-style paper filter may also be used.
How to Use Carafe Side (cont.) 9 Place brew basket in brew basket well. Ensure brew basket is fully seated. 10 For enhanced full/strong-flavored coffee, press BREW OPTIONS button until BOLD is displayed. 11 Press I/O (ON/OFF) button to start. Press I/O (ON/OFF) button again to turn off. NOTE: If the coffeemaker is not turned off manually, it will automatically shut off in 2 hours. NOTE: BOLD mode will require additional time to complete a brewing cycle.
Programming (For Either the Single-Serve OR Carafe Side) NOTE: The unit will only brew on one side at a time. 1 Press HOUR and then MINUTE to set clock. 2 Hold PROGRAM until clock flashes. 3 Continue holding PROGRAM button, press HOUR and MINUTE until the desired brewing start time is reached, and then release PROGRAM button. 4 Press PROGRAM to activate automatic brewing. A green LED will illuminate to indicate the unit is programmed.
Care and Cleaning – Single-Serve Side All coffeemakers should be cleaned at least once a month (once a week for areas with hard water). 1 2 3 Pour 1/2 cup (125 ml) of plain white vinegar and 1/2 cup (125 ml) of cold water into single-serve side reservoir. 5 Run 2–3 more brew cycles with CLEAN WATER only. Allow to cool between cycles. 10 6 4 Press I (ON) button. Press O (OFF) button after 30 seconds and wait 30 minutes. Press I (ON) button. Press O (OFF) button when finished.
Care and Cleaning – Carafe Side All coffeemakers should be cleaned at least once a month (once a week for areas with hard water). 1 2 3 Pour 1 pint (2 cups/500 ml) vinegar into carafe side reservoir. 5 4 Press I (ON) button. Press O (OFF) button after 30 seconds and wait 30 minutes. Press I (ON) button. Press O (OFF) button when finished. 6 DISHWASHER-SAFE Run 2–3 more brew cycles with CLEAN WATER only. Allow to cool between cycles.
Troubleshooting (Single-Serve Side) PROBLEM PROBABLE CAUSE Weak coffee. • Not enough ground coffee used. See “How to Use Single-Serve Side.” Coffee overflows from brew basket, travel mug, or regular mug. • Excessive amount of water in single-serve reservoir. Use travel mug or mug into which coffee will be brewed to fill reservoir. Use slightly less grounds when brewing decaffeinated or flavored coffees. Set coffee grinder to automatic drip grind. Coffee tastes bad. • Coffeemaker needs cleaning.
Troubleshooting (Carafe Side) PROBLEM PROBABLE CAUSE Brew basket overflows or coffee brews slowly. • Excessive amounts of ground coffee. • Decaffeinated and/or coffee ground too finely can cause overflow. Set coffee grinder to automatic drip grind and use slightly less grounds. • Coffeemaker needs cleaning. If using a paper filter: • Coffee grounds between paper filter and brew basket. • Paper filter not open and in proper position.
Troubleshooting (Carafe Side) (cont.) PROBLEM PROBABLE CAUSE Coffee sediment in cup. • Use a high-quality, basket-style paper filter instead of permanent coffee filter. Coffee not brewing or unit will not turn on. • Carafe not positioned on keep-hot plate. • Water reservoir is empty. • Unit is unplugged. • Power outage. • Power surge. Unplug; then plug the unit back in. • Clock requires reset after power outage. Longer than normal brew time.
Notes 15
Limited Warranty CUSTOMER NAME: ADDRESS: PHONE NUMBER: MODEL NUMBER: DATE OF PURCHASE: NAME OF DEALER: DEALER’S SIGNATURE: CUSTOMER’S SIGNATURE: STAMP: BILL NUMBER: SERIAL NUMBER: (PLACE SERIAL NUMBER STICKER HERE) EXPIRY DATE: SHOULD ANY DEFECT IN MATERIAL OR WORKMANSHIP DEVELOP IN THE PRODUCT, • CALL 1.800.42.555.43 OR VISIT www.hamiltonbeach.in FOR SERVICE CENTER LOCATIONS OR • KINDLY TAKE THE PRODUCT TO THE PLACE OF PURCHASE OR • CALL 1.800.42.555.