Use and Care Guide

6
TO TEST ALCI PROTECTION DEVICE
This appliance is equipped with a polarized
Appliance Leakage Circuit Interrupter plug
(ALCI). This device will shut off hair dryer
automatically under certain abnormal operating
conditions, such as submersion of dryer in
water.
The ALCI must be tested before each use of
hair dryer.
1. Make sure ALCI is plugged in; then press Reset button on ALCI.
2. Press Test button. Reset button should pop out, which indicates
ALCI is working properly.
NOTE: If Reset button does not pop out during test, or pops
out before or during operation, or if hair dryer fails to function
properly, do not operate hair dryer. Refer to product warranty.
3. Press Reset button again to reactivate the ALCI. You are now
ready to operate the hair dryer.
4. If Auto Monitoring Light stays on or continues to blink, or
Reset Button continues to pop out, the ALCI is not functioning
properly. Stop using Hair Dryer and email customer service for
information on examination and repair.
5. In addition to the above required manual test, your ALCI plug
will automatically conduct a test every few minutes. If the Auto
Monitoring Light stays on or continuously blinks or the Reset
Button pops out, unplug and allow the appliance to cool. Press
Reset Button and plug into outlet. The appliance should then
function normally. If not, email customer service for further
instructions.
ALCI
Plug
Operating Instructions