Operation Manual

36
37
6.1 ATM VC: (DSL modem setting) Asynchronous Transfer Mode (ATM) is a method of transferring data whereby the data traffi c is transferred in small packets, and the transfer is coded and asynchronous. You must enter the following values, which differ according to the DSL connection. Virtual Circuit: PVCO is selected by default. Status: Activated must be selected. VPI: 1 VCI: 32 Note: The values 1 and 32 are only valid for the Deutsche Telekom DSL connection. If your connection is through a different company or you are not resident in Germany, ask your DSL connection provider for these values. Click SAVE at the bottom of the window to save your settings. 6.2 Encapsulation: (DSL protocol) The purpose of encapsulation is to encapsulate other protocols and to transport these in the form of IP tunnels. In Germany, the PPPoE protocol is used almost exclusively; this manual will therefore cover this protocol only. Users with different protocols should consult their internet service provider, which will provide the relevant setting information. Click SAVE at the bottom of the window to save your settings. 6.3 PPPoE/PPPoA: (Broadband connection protocol) PPP over Ethernet (PPPoE) is the use of the Point-to- Point Protocol (PPP) with an Ethernet connection. PPPoE is currently used for ADSL connections in Germany.
5 Interface Setup In this screen, you can change the standard LANsettings of the router. In the Main Menu, select the Interface Setup menu item, followed by the LAN sub-item. 5.1 Router local IP: The IP Address of the router is set to 192.168.2.1 by default. If you want to use a different address for the router, you can make the necessary changes here. The corresponding IP Subnet Mask is entered in the fi eld directly below this. All other fi elds are only relevant for specialised application areas, which cannot be explained in depth here. We recommend that you keep the default settings. Click SAVE at the bottom of the window to save your settings. Warning: The new LAN configuration takes effect after restarting. You must therefore use the new IP address to open the web interface in the browser. 5.2 DHCP Server: The integrated DHCP server allows IP addresses to be assigned to connected clients automatically. Select Disabled if you assign the IP addresses manually in your network, and therefore do not need a DHCP server. Select Enabled if you want to use the DHCP server. The Lease Time setting specifi es how long the assigned IP address is to apply for the client. The IP address range from which the DHCP server can assign IP addresses to clients is restricted by the Start-IP Address and the End-IP Address. Click SAVE at the bottom of the window to save your settings. 6 Internet Settings In this screen, you can change the parameters for the integrated ADSL2+ modem in the router. In the Main Menu, select the Interface Setup menu item, and then the Internet sub-item. The most important settings in this area are explained below: