Operation Manual

8
Deutsch
Step 4 To save the changes made in the menu, press the key.
Step 5 To exit the menu function press the key.
If the original remote control of your component features a separate menu exit
key, press the key at your universal remote control to exit the menu function.
Menu control for your SAT receiver (only for M5):
Step 1 Press and release key. Your SAT receiver should now show the
settings menu.
Step 2 The LED is continuously on.
Step 3 Navigate through the menu options by pressing the , , and keys.
Step 4 To save the changes made in the menu, press the key.
Step 5 To exit the menu function press the key.
Menu control for your DVD player (only for M5):
DVD film menu:
Step 1 Press and release key. Your DVD player should now show the DVD
menu.
Step 2 Navigate through the menu options by pressing the , , and keys.
Step 3 To save the changes made in the menu, press the key.
Step 4 To exit the menu function press the key.
DVD setup menu:
Step 1 Press and release the key to access the shift mode. (The LED is
continuously on).
Step 2 Press and release key. Your DVD player should now show the setup
menu.
Step 3 Navigate through the menu options by pressing the , , and keys.
Step 4 To save the changes made in the menu, press the key.
Step 5 To exit the setup menu press the key.
Step 6 Press the key to exit the shift mode.
If your device supports a specific function, but you cannot control the function
with your universal remote control remote control, you might be using an
incorrect code. Test all other codes listed in the enclosed code list for your
device brand or start the automatic code scan to find a better code for your
device.
Controlling brightness, contrast, colour, treble, bass
and balance
If your device does not support the control of the brightness or colour by
means of the universal remote control menu function and if there is a special
control button for this analogue function, proceed as follows:
Step 1 Press and release the key to access the shift mode. (The LED is
continuously on).
Step 2 Press one of the following keys to change the settings:
Key for brightness
Key for contrast
Key for colour
Key for treble
Key for bass
Key for balance
Step 3 Press the and keys to control the selected analogue function
(brightness, contrast, colour, treble, bass or balance).
Step 4 To exit the mode for the control of the analogue functions, wait 10
seconds and then press the key to exit shift mode. The LED is now
off.
USER MANUAL
GB