Operation Manual

6
Deutsch
Identifying the correct 4-digit code (after having run an
automatic code scan)
After using the automatic scan mode the remote will have selected a code
which is unknown to you. Its important to know which code has been found so
that it can be reinstalled should something happen to the remote. Please follow
the steps below.
Step 1 Select the device that you wish to control with your universal remote
control by turning the disk until the arrow points to the desired device.
(only for M5)
Step 2 Press the key until the LED flashes twice (after approx. 2 seconds).
Step 3 Within 5 seconds enter code 0030. The red LED flashes twice,
indicating that the remote control is now in "code identify mode".
Step 4 To identify the currently saved code, press the following keys:
for first digit
for second digit
for third digit
for fourth digit
These keys must be pressed in the above sequence. After each digit
key has been pressed, count the number of times the red LED flashes.
To repeat the reading procedure, press any of the four keys again
within 5 seconds. Repeat the reading until you are sure that you have
the correct code written down.
When reading the code, also include the initial flash of the LED upon
the pressing of keys into your count.
PLEASE NOTE!
If the LED does not flash after you have pressed one of the above selection
keys, the respective code digit is 0.
Example:
Press key for thousands. The LED flashes once. The first digit of
your 4-digit code is thus 1.
Press key for thousands. The LED flashes three times. The second
digit of your 4-digit code is thus 3.
Press key for tens. The LED flashes five times. The third digit of your
4-digit code is thus 5.
Press key for units. The LED flashes three times. The last digit of
your 4-digit code is thus 3.
In this example, the code is thus 1353.
We recommend that you write down the codes for your device in the respective
field in this manual so that they are available in case you need to re-program
your universal remote control. Please keep this booklet in a safe place for
future use!
Write down the 4-digit codes here:
USER MANUAL
GB