Operation Manual

4
Deutsch
The 5-second rule
universal remote control initially needs your assistance to work properly.
All programming is based on the 5-second rule: every step in these instructions
must be completed within 5 seconds after the previous step. Otherwise, the
remote control returns to standard operating mode. This rule ensures that your
remote control is not inadvertently reprogrammed by another user.
Quick setup
Step 1 Insert the batteries (correct position is indicated at the base of the
battery slot).
Step 2 Select the device that you wish to control with your universal remote
control by turning the disk until the arrow points to the desired device,
(e.g. TV). (only for M5)
Step 3 Switch on your device (to programme the remote control for the TV
set, ensure that the television shows a picture).
Step 4 Press the key and keep it pressed until the LED flashes twice in
quick succession. (after approx. 2 seconds).
Step 5 Within 5 seconds of seeing the 2 flashes above, enter the 4 digit code
indicated for your device in the separate code list book.
Step 6 After you have entered the code the LED will flash twice, indicating
that the code has been accepted by your universal remote control.
This does not necessarily mean it is the correct code for your model of
device.
Step 7 Press the key to check whether your universal remote control is
working properly. If your device is thereby set to standby mode, check
all other functions of the remote control. If certain functions are not
available or not working properly, refer to the next code in the list and
repeat the programming procedure from step 3.
Step 8 Please keep this booklet in a safe place for future use!
Tips If your device does not respond to any of the code numbers:
Q. None of the code numbers worked?
A. This might be because more than 5 seconds lapsed before you entered the
code or because you input an invalid code number In this case, check that
you have entered the correct 4-digit code or repeat the programming
procedure with the next code in the list whilst observing the 5 second
programming rule.
Q. My brand of TV is not listed in the code book?
A. Do not worry, simply read the section entitle “Automatic code scan”.
Programming for AUX devices (only M5)
The AUX option allows you to control an additional device with your universal
remote control.
By positioning the disk to point to DVD/AUX, you have the option to control a
second TV set, video recorder or SAT receiver instead of a DVD player.
To program your remote control for a second TV set, please proceed as
described in the programming instructions for television sets. However, you
must ensure that the rotary pointer is positioned at DVD/AUX.
For programming, please following the above instructions for quick setup.
PLEASE NOTE!
With manual code entry, all codes (TV, VCR, SAT and DVD) are permitted for
selection DVD/AUX. However, the automatic code scan for DVD/AUX only
searches for DVD codes.
USER MANUAL
GB