Manual
Table Of Contents
- Introduction
- SECTION 1 Getting Started
- CHAPTER 1 HALTECH IG5 INSTALLATION
- 1.1 Overview
- 1.2 Installation Summary
- 1.3 Expanded Installation Guide
- 1.3.1. Manifold Absolute Pressure (MAP) Sensor
- 1.3.2. Coolant Temperature Sensor
- 1.3.3. Inlet Air Temperature Sensor
- 1.3.4. The Throttle Position Sensor (TPS)
- 1.3.5. Mounting the Igniter
- 1.3.6. Route Wiring Harness and Connect Sensors
- 1.3.7. Power Relays
- 1.3.8. Electronic Control Unit (ECU)
- 1.3.9. Flying Leads
- 1.3.10. Install and connect any Optional Outputs
- 1.3.11 Connect the Trigger Sensor
- 1.3.12 Connect the ECU
- CHAPTER 2 GETTING ONLINE
- CHAPTER 3 ENGINE IDENTIFICATION
- CHAPTER 4 USING HALTECH SOFTWARE
- CHAPTER 5 STARTING THE ENGINE
- CHAPTER 1 HALTECH IG5 INSTALLATION
- SECTION 2 Other Adjustable Features
- SECTION 3 Software Features
- SECTION 4 IG5 Optional Outputs
- CHAPTER 12 SOFTWARE ACCESS
- CHAPTER 13 AUXILIARY OUTPUTS
- 13.1 Description
- 13.2 Turbo Waste Gate Control (TWG)
- 13.3 Dual Intake Valve Control (DIV)
- 13.4 Torque Converter Lockup (TCC)
- 13.5 Electric Thermatic Fan Control (TF)
- 13.6 Electric Intercooler Fan Control (IF)
- 13.7 Shift Light Illumination (SL)
- 13.8 Anti-Stall Solenoid Control (AS)
- 13.9 Turbo Timer (TT)
- 13.10 NOS Switch
- SECTION 5 Appendices
59
A.2 Control Program Problems
Haltech Programming Software will not start up
The Haltech programming software should run on any computer that meets the requirements
in Chapter 2. If, after following the instructions in Chapter 3, the program will not run, the
most likely cause will be insufficient memory. If this is the case, you must make more free
memory available before running the software.
Always start from the DOS prompt. Do not try running the Haltech software from out of
another shell program. If you are loading a number of TSR (Terminate and Stay Resident)
utilities during boot up, you may need to disable them before running the Haltech software.
Refer to your computer and DOS reference manuals on memory management.
Alternatively, you may make your Haltech disk boot-able by placing it in floppy drive A: and
typing:
c:\> sys a:
We recommend that you make a backup of the original disk before trying this. You should
then be able to restart your computer with the disk in drive A:, and the Haltech software will
load and run automatically.
If the software still does not run, and you see the message "Error ### at xxxx:xxxx", record
these numbers (or letters) and contact your Haltech dealer.
Haltech Programming Disk will not run Online
If the Haltech ECU does not respond to the Programming software requesting information,
then the message RECONNECT HALTECH will be displayed. This situation will occur
under the following conditions
• ECU is not powered up
• Programming Cable is not connected
• Incorrect COM port selected - see Chapter 13
• Wrong Programming Disk (ie. disk does not match ECU)
• Programming Cable is damaged
• Serial port of programming computer is faulty.
If the disk is the wrong version or you suspect that the cable is faulty, contact your Haltech
dealer or try another program cable.