Owner's manual

Rear Auxiliary Connector
The Platinum Pro Plugin Series allows further expansion of your ECU by the
Rear Auxiliary Connector.
The Rear Auxiliary connector allows you access to:
• 2 Additional Digital Pulsed Outputs ( DPO )
• 2 Additional Digital Switched Outputs ( DSO )
• 2 Additional Analogue Voltage Inputs ( AVI )
• 2 Additional Analogue Temperature Inputs ( ATI )
These extra Inputs / Outputs can be used to:
• Fit additional sensors. (eg MAP and Temperature)
• Control additional devices via relays
• Control additional solenoids directly (eg Aftermarket Boost Control solenoid)
The Rear Auxiliary harness is available as an optional extra. ( HT040003 )
Figure 7 - Rear Auxiliary Harness Connector and Pinout
6. With the engine started and running its time to tune. This is best achieved by your
nearest engine tuner. See the listing of Haltech dealers on our website to find the one
closest to you. Go to www.haltech.com
Figure 5 – Haltech ECU Manager Software tuning page
7. Re-install the Glove compartment and lower cover to the vehicle.
Figure 6 – Glove compartment and lower cover Re-installed
Pin # Wire Colour Connection
1 O +5V
2 Y AVI1 (MAP)
3 O/B AVI2
4 B/W SIGNAL GROUND
5 V/B DPO1
6 V/BR DPO2
7 - -
8 - -
9 O +5V
10 GY ATI1 (AIR)
11 GY/B ATI2
12 B/W SIGNAL GROUND
13 V/R DSO1
14 V/O DSO2
15 - -
16 - -
1234
9101112
5678
13141516
Looking into Back Of Connector