Manual

7
• Throttle Position Sensor
10 kΩ rotary potentiometer driven from throttle shaft
• Engine Speed Pickup
Compatible with most “ standard trigger” systems:
- 5 or 12 volt square wave;
- Pull-to-ground (open collector)
- Coil Negative triggering
ECU O utpu ts
• Injector Driver
F10 and F10A Only
8 x 4/1Amp peak-and-hold current limiting drivers:
- Up to 4 low-impedance injectors*
- Up to 8 high-impedance injectors*
F10-8 and F10A-8 Only
8 x 4/1Amp peak-and-hold current limiting drivers:
- Up to 8 low-impedance injectors*
- Up to 16 high-impedance injectors*
(Expandabl e using optional Driver Box; Refer B.3 Injector Driver Box, 88)
F10A and F10A-8 Only
• Pulse Width Modulated (PWM) Output
4 x Dedicated PWM outputs
- Suitable for controlling turbo wastegate, solenoids, valves, shift lights, etc.
• Fuel Pump Control
20A fused relay, features automatic priming and switch-off.
F10A and F10A-8 Only
• Stepper Motor driver for idle control
Capable of driving bipolar stepper motors used for idle control.
* Additional hardware may be required
System Programming Requirements
• Computer
IBM-PC or compatible, preferably laptop or notebooks
CGA, EGA or VGA, colour or monochrome display
640+ kb RAM
• Disk Drive
3.5" Floppy Disk Drive
(5.25" disk available on request)
• Serial Port
Standard RS232C port - 9 pin D connector
(25 pin cable available on request)
COM1 or COM2 (selectable)