Operating Instructions

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING: When using this product, basic precautions should always
be followed, including the following:
• Improper use of this product may result in product damage, excess
heat, toxic fumes, re or explosion, for which damages you
(“Purchaser”), and not HALO2CLOUD LLC. (HALO) (“Manufacturer”) are
responsible.
• Do not store device in high-temperature environment, including heat
caused by intense sunlight or other forms of heat. Do not place device
in re or other excessively hot environments. Exposure to re or
temperature above 212°F (100°C) may cause explosion.
• Do not expose the wireless charger to rain or snow.
• Do not use the wireless charger in excess of its output rating.
Overloading outputs above rating may result in a risk of re or injury
to persons.
• Do not disassemble this product or attempt to re-purpose or modify
it in any manner.
• Do not attempt to replace any part of this device.
• For questions or instructions for the various ways to charge this
device, refer to the illustrations in this quick-start guide.
• Use of a power supply or charger not recommended by HALO may
result in a risk of re or injury to persons.
• Use only the supplied AC adapter to power the wireless charging
base. The wireless charging base may not work properly when
connected to any other AC adapter.
• If this device is accessible to or may be used by a minor, purchasing
adult agrees to be solely responsible for providing supervision,
instruction, and warnings. Purchaser agrees to defend, indemnify, and
hold Manufacturer harmless for any claims or damages arising from
unintended use or misuse by a minor.
• All products have gone through a thorough quality assurance
inspection. If you nd that your device is excessively hot, is emitting
odor, is deformed, abraded, cut, or is experiencing or demonstrating
an abnormal phenomenon, immediately stop all product use and
contact Manufacturer.
• Switch o the wireless charger when not in use. The wireless charger
will automatically switch o when disconnected from its wall charger.
• To disconnect the charging pad from line voltage, pull the AC adapter
from the AC outlet.
• The AC outlet shall be installed near the charging pad and shall be
easily accessible.
• To comply with FCC RF exposure compliance requirements, the
wireless charger must be used with a separation distance of at least
20 cm from all persons.