Technical Bulletin

Dimmer Notes:

1) Start time is measured at the lowest dimmer setting.

2) Some LED dimmers have a "rapid start" design used to provide a momentary power boost to LED and CFL lamps during start-up.

When a LED luminaire is on a dimmer with "rapid start" the boost may cause a momentary ﬂash of the LED lighting. This "ﬂash" is

generated by the dimmer, and may be more noticeable when the dimmer is at a low setting. A solution is available with EATON

dimmers which provide adjustment capability of the "rapid start": Devine (DAL06P), Accell (AAL06P), and Trace (TAL06P). Refer to

product speciﬁcations online at www.eaton.com for more details.

Dimming Guide Disclaimer:

1) Leviton

is a registered trademark of Leviton Manufacturing Co. Inc.; Lutron

is a registered trademark of Lutron Electronics Co.

Inc.; Lightolier

is a registered trademark of Philips Lighting; Hubbell

is a registered trademark of Hubbell Incorporated; Legrand

and Pass & Seymour

are registered trademarks of Legrand

; Eaton

is a registered trademark of Eaton Corporation. These companies

and their tradenames, trademarks or brands, where noted, are associated with their respective company and are not associated with

Cooper Lighting Solutions.



2) Testing conducted by Cooper Lighting Solutions is not a substitute for and does not imply certiﬁcation by an independent laboratory or

any other standards certiﬁcation.Refer to the manufacturer speciﬁcations for more detailed information on product certiﬁcations and

standards.

3) This is a representative list of typical dimmers as tested by Cooper Lighting Solutions for performance with the designated LED

luminaires only. Test data contained in this literature is based upon dimmers obtained in the marketplace.Information about these

other manufacturers products is obtained from packaging and published information made available by the manufacturer and is

deemed to be reliable, but has not been veriﬁed.Dimmer performance and perceived limitations of the dimmers are based on factors

outside of Cooper Lighting Solutions' control.The speciﬁcations of these dimming controls and their conditions of use may change

without notice to Cooper Lighting Solutions or any other user.Cooper Lighting Solutions makes no speciﬁc recommendation on

product selection and

there are no warranties of performance or compatibility implied. Installer must ensure proper local and national electrical codes are

followed; and that the dimmer application and condition of use is per dimmer manufacturer instructions and guidelines.

TD51814622 page 10

March 18, 2022 9:12 AM