Instructions / Assembly

OPERATION AND STORAGE
Warning: User shall pour lava rocks fully to cover the whole burner before operaon.
TO TURN ON THE FIRE PIT
1. Turn the control knob to the “OFF”posion (Figure a).
2. Fully open LP cylinder valve.
Note: For inial start or aer any cylinder change, hold Control Knob IN for 10 seconds to purge air from
gas lines before proceeding.
3. Push in gas control knob and turn counterclockwise to “IGNITER”(Figure b) to light the fire pit. If
needed, keep pressing and turning control knob counterclockwise unl the heater lights (You should hear
a clicking sound).
4. Aer fire pit lights, release control knob. Push in and turn the control knob to the “HIGH”(Figure c),
then release control knob. If you want a lower temperature, push in the control knob and turn clockwise
to the “LOW”. Note: If burner fails to remain lit, all valves should be closed and a waing period of at least
5 minutes should pass before aempng to light.
TO TURN OFF THE FIRE PIT
1. To exnguish burner depress control knob and connue to turn it clockwise to OFF.
2. Turn cylinder valve clockwise to OFF and disconnect regulator when fire pit is not in use.
LOW
HIGH
OFF
Figure a
LOW
HIGH
OFF
Figure b
LOW
HIGH
OFF
Figure c
OFF: the heater stop work
HIGH: maximum temperature posion
LOW: minimum temperature posion
Storage
1. Always close the gas valve of the gas cylinder aer use or in case of a disturbance.
2. Remove the pressure controller and the hose.
3. Check the ghtness of the gas valve and for damage. If you suspect a damage, have it changed by your
gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places without adequate air venlaon.
9