Fire Pit Glass Wind Guard Instructions
Paking Lists Part Img Part Name Qty A Short Glass 2 PCS B Long Glass 2 PCS C Top Corner Connector 4 PCS D Bottom Corner Connector 4 PCS E M8 x 10 16 PCS F Hand Screw Driver 1 PC
Part E Description Extra Description Qty M8 x 10 2PCS WARNING:Failure to locate parts in accordance with these diagrams, or failure to use special parts provided with this equipment, may result in property damage or personal injury.
Step1:Fasten the top corner connector(C) and bo�om corner connector(D) to the long glass(B) with screws(E). Note: Please �ghten the screws. D C B F E B Long Glass C Top Corner Connector D Bottom Corner Connector E M8 x 10 F Hand Screw Driver Step2:Fasten the short glass(A) with screws(E) on the top corner connector(C) and the bo�om corner connector(D). Note: Please �ghten the screws.
Step3:Fasten the top corner connector(C) and bo�om corner connector(D) to the short glass(A) with screws(E). Note: Please �ghten the screws. A B D E F C A Short Glass B Long Glass C Top Corner Connector D Bottom Corner Connector E M8 x 10 F Hand Screw Driver Step4:Fasten the other long piece of glass(B) with screws(E) on the top corner connector(C) and the bo�om corner connector(D). Note: Please �ghten the screws.
Step5:lnstalla�on completed. Warning Never place your wind guard directly on the fire pit insert. Always ensure the rubber feet are used. Always ensure the silicon insert is on the set screws. Always ensure there is a 1/2gap between the glass panels. Always check the glass panels for cracks.DO NOT use glass panels with a crack. Maintenance: Clean the glass 2-3 times per season or as needed.
CARE AND MAINTENANCE Follow the instruction for the material of your special product to make sure that it stays in the best shape for as long as possible.The information below is only intended as a general guideline.For more information，please contact us. Only need to rinse it thoroughly with clean water to wash away dirt and grime.Never use abrasive cleansers on the furniture. since it can attack the surfaces and leave behind scratch marks.
