Use and Care Manual
Store excess wires in the wiring box.6.
Install both chimneys and tighten screws to secure the lower 7.
chimney to the range hood as shown in Figure 5.
To avoid scratching the chimney, extend the upper chimney 8.
slowly and carefully to the chimney-mounting bracket and
tighten screws as shown in Figure 6.
Place grease tunnel into recess support near rear of hood. Refer to Figure 7.9.
To install stainless steel bafe lters, refer to Figure 8 for the following ve steps:10.
Angle bafe lter toward back of hood.
Push bafe lter up until almost level.
Slide forward into recess behind the front of hood.
Lower bafe lter.
Slide back until it ts into resting positions.
Repeat Step 12 to install all stainless steel bafe lters.11.
Turn power ON in control panel. Check all lights and fan operations.12.
Make sure to leave this Installation Guide for the homeowner.13.
Page 11
Installation (Continued)
Figure 6
Figure 5
Figure 7
Figure 8