Energy Guide

7
UHBX-R-XT
4.0 Configuration
As shipped, no user configuration is needed for extending HDMI video. By
default the length of CAT6 cable plugged to the input can be as long as 100
meters (328 ft). The length of CAT6 cable plugged to the output depends on
the downstream receiver, but by default it too is good for at least 100 meters.
To achieve even longer distances, the receiver has a "Long Reach" mode
setting. If the HDBaseT “Source Device” connected to the input of the
receiver also supports "Long Reach" operation, 1080p video (with 8-bit color)
can be extended to 150m (500 ft). So if in your setup there is no choice and
you have to go beyond 100m, you have this option (limits your color depth to
8 bit, and resolution to 1080p).
If RS-232 control output is going to be used (for example to control on/off
function of compatible TV or projector connected to the HDMI output, please
refer to section 4.5
below.
4.1 Distance Mode Switch
This switch affects the operation at the HDBaseT input. It
is recommended to leave it in AUTO. In LR mode, UTP
cable lengths of up to150 meters can be accommodated.
The slide switch is located under the HDMI OUTPUT
connector. To enable Long Reach mode place the switch
in L.R. position (use the tip of a pencil or a paper clip).
Mode
UTP Length
Notes
Auto
0 to 100 m (330ft)
Default setting
L.R. 0 to 150 m (450ft) Long Reach setting
Supports maximum of 1080p@60 Hz, 8-bit.
1080p deep-color and 4Kx2K are not supported
4.2 LED Indicators
The front panel contains LEDs that show the state of operation at the input and
daisy-chain output.
LED Indicators