Energy Guide

Daisy Chainable HDBaseT™ Receiver
10
or projector connected, is also kept in a buffer and is readable through the
HDBaseT by the controller connected to the HDBaseT transmitter.
Using HDBaseT to send an internally stored command
To use this method, the user must have uploaded commands in the internal
memory of the UHBX-R-XT. Using the serial port on the HDBaseT sender,
the user can address a particular box and ask it to send out one of its 6 internal
commands.
Sending commands automatically by detecting video
The UHBX-R-XT can be set to send out the first two internal commands
automatically based on detecting video in the HDBaseT. Only the first two of
the internal commands are used, the first one is sent out when video is detected
(typically used to turn on a display), and after video is absent for a given
amount of time (the time is specifiable using the USB GUI), the UHBX-R-XT
will issue the off command.