Owner manual

VGA / HDTV Video Processor

OUTPUT

Use arrows to adjust output mode. Refer to Section 5.2 below for

a list of all available modes.

The default output resolution after a factory reset is “NATIVE”

with the input source set to “AV”.

The unit has non-volatile memory and memorizes all your

settings before power off and recalls those settings on the next

power on.

At any time, pressing the UP ARROW ▲ and MENU button

together will change the output resolution to XGA@60Hz.

Pressing the MENU and DOWN ARROW ▼ together will

change the output resolution to 480P@60 Hz.

OSD

When selected, a sub menu of input signal capture adjustments

will appear.

H-POSITION – Adjust horizontal position of the OSD on the

screen. (default = 10)

V-POSITION – Adjust vertical position of the OSD on the screen.

(default = 90)

TIMER – Select the number of seconds for the OSD to be

displayed on the screen before turning off. (default = 10)

BACKGROUND – Changes opacity of the OSD background on

the screen. (default = 63)

Factory Reset

Select this option to reset all values to the factory defaults. Since

this sets the INPUT source as “AV”, you may need to select the

“S-VIDEO” source by pressing the “-“ button with no OSD

selected to get a picture.

Information

Displays source type, Input resolution, output resolution and

firmware version.

Mirror

If enabled; this function will flip the image horizontally on the

screen.