Single Seat Trailer Owner’s manual and safety instructions
Owner’s Manual Every effort has been made to ensure your trailer is of top quality and proven safe design, ready to provide you with many years of safe, happy use. Please read this manual and instructions fully before assembly and use. Please keep this manual for future reference. If you sell or give this product to someone else, please include this Owner’s Manual, and ask the new owner to read the instructions thoroughly before using.
ASSEMBLY INSTRUCTIONS 1A 1B 1A. 1B. Remove all of the contents from inside the carton and place them on a clean flat surface. Check all the contents against the parts list on page1. Check the contents also for damage. Set the wheels to the side and remove the black plastic protective caps from the ends of the axles. Remove the rain canopy and flag pole assembly from inside the trailer. STEP 2 Assemble the canopy frame 2A 2B 2C Q/R safety pin Q/R safety pin 2A. 2B. 2C.
STEP 3 Adjust the sling seat 3A 3B Area of detail in photo 3B 3A. 3B. Front view of the trailer with the crossbar secured in place. To provide more comfort, the sling seat can be adjusted by pulling on one or both sets of straps that run underneath the bottom of the seat. Loosen the straps to allow the trailer to fold flat. STEP 4 Attach the 2-in-1 canopy 4 4. Lay the canopy over the top of the trailer frame with the large window toward the front.
STEP 6 Attach the wheels to the quick-release brackets and make sure they are secure 6A 6B 6C 6A. 6B. 6C. Locate the rear wheel brackets on each side of the trailer and read the warnings carefully. Push one wheel axle completely through the bracket hole until you hear the axle click into place. IMPORTANT! Pull firmly on each wheel to ensure the lock mechanisms are securely engaged! STEP 7 Extend and secure the tow bar 7A 7A. 7B. 7C. 7D.
STEP 9 Attach trailer tow bar to bike 9A 9B 9A. 9B. 9C. 9D. 9C Tighten the bike hub nut securely with a wrench. Locate the front end of the tow bar around the coupler. Push the quick release pin through the holes in the tow bar and the coupler and fasten securely. Loop safety strap around bike frame and clip the end into the “D” ring at the end of the tow bar. WARNING Safety strap must be attached to the bike frame when using this product in trailer mode.
STEP 12 Install the safety flag 12A 12B 12C Flag pole Sleeve 12A. 12B. 12C. Connect the flagpole sections and find the small opening near the top left edge of the canopy. Slide the end of the flagpole through the opening in the canopy. Slide the pole all the way down into the flag pole sleeve near the rear corner.
REMOVAL, DISASSEMBLY, AND STORAGE INSTRUCTIONS Removal of the trailer from the bike 1. Remove children from inside the passenger compartment. 2. Unclip the tow bar safety strap from the “D” ring. 3. Loop the strap back around the bike frame tube so that the strap is free of the bike frame. 4. Clip the end of the strap back on to the tow bar “D” ring. 5. Remove the quick-release pin from the tow bar coupler. 6.
SAFE TOWING TIPS WARNING Use a foot pump or hand pump to inflate tyres! Pressurized air hoses can cause over-inflation! WARNING Accessories or parcels placed in trailer/stroller may cause it to become unstable! WARNING Never use this trailer/stroller if it becomes damaged! WARNING To avoid serious injury, children should always wear the seat belt and the shoulder straps! WARNING Never leave children unattended in or around this trailer! WARNING Make sure your bike brakes work properly! Braking distance is
