User Manual

FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual

p/n: 029-0021-68-0

Electrical Installation ❑

10. Install and

tighten the 5/

8” (16mm)

tube compres-

sion nut.

11. Slide the 1/2”

diameter tube

in the 5/8”

(16mm) diam-

eter tube and

adjust the tele-

scoping sec-

tion until the

desired length

is achieved, as

measured

from the bot-

tom of the

flange to the

bottom of the

sensor.

Tighten the

compression

fittings on the

union to lock

length setting.

12. Tighten the

strain relief

gland nut and

strain relief.

Low Level Sensor Wiring

CAUTION !

WHEN EXTENDING THE LOW TANK SENSOR WIRES MAKE SURE THE

SPLICES ARE PROPERLY SEALED USING AN ADHESIVE FILLED HEAT

SHRINK TUBING.

Figure 3-40: Top Mount Low Level Sensor Assembly