User Manual

FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual

p/n: 029-0021-68-0

Installer Installation ❑

3 Installation

Carefully review the procedures that follow to ensure the system is properly

designed. This section lists components that have been tested with Hale Foam-

Logix and provide the best system performance. Using the recommended materi-

als and specified parts ensures a virtually maintenance free installation.

Differences in apparatus plumbing and foam system configuration make it impracti-

cal to show exactly how the Hale FoamLogix 3.3, 5.0 or 6.5 system is installed on a

particular apparatus. The information contained in this section applies to most situ-

ations and should be used when designing and installing a Hale FoamLogix 3.3,

5.0 or 6.5 system. System plumbing and electrical diagrams are provided to assist

with installation.

Before proceeding with system installation, carefully review the procedures that fol-

low to ensure the system is properly designed.

The Hale FoamLogix system is supplied with six major components that must be

located on the apparatus.

❑ Foam pump and motor assembly

❑ Control unit

❑ In-Line foam strainer/valve assembly

❑ Instruction/system diagram placard

❑ Flow Sensor

❑ Check valve injector fitting

Notes: The flow sensor and check valve injector fitting may be pre-mounted, if a

manifold or pre-configured package is ordered.

Optional components that require mounting on the apparatus include:

❑ ADT operating switch and indicator lights

❑ Flanged elbows

❑ Foam tank(s)

❑ FS-15 or FS-25 panel mounted foam strainers

❑ Manual “dual” tank (MDT II) selector valve

❑ Manual “single” tank (MST) selector valve

❑ Mini Manifold

❑ Remote activation switch