User guide

7
AUTOFIll-E Installer / User Guide
p/n: 029-0020-81-0
Safety Precautions ❑
❑ To prevent electrical shock always disconnect the primary power source
before attempting to service any part of the Hale AutoFill-E system.
❑ All electrical systems have the potential to cause sparks during service.
Take the necessary precautions to eliminate explosive or hazardous
environments during any installation/service.
❑ Relieve all system pressure, then drain all foam concentrate and water
from the system before servicing any of its component parts. Lockout
the system in accordance with the manufacturer’s recommendations.
❑ Use only tubing which is rated at or above the maximum discharge pres-
sure of the fire pumping system, i.e., 50 PSI (34 BAR) minimum.
❑ Fasteners used for the installation of the Hale AutoFill - E System are
Grade 5, and some are stainless steel. NEVER substitute with a lesser
grade fastener or quality. Failure to do so could cause equipment mal-
function or damage and/or personal injury.
❑ Use only approved lubricants on the Hale AutoFill-E System. Hale rec-
ommends using: Never-Seez®, White Food Grade with PTEE
Never-Seez is available from:
Bostik Findley, Inc
211 Boston Street
Middletown, MA 01949-2128
Web......www.bostikfindley-us.com