User guide

ΙΙΙ-3
ROTARY GEAR PUMP
ELECTRONIC FOAM PROPORTIONING SYSTEM
Section III: Set-up and Calibration
INSTALLATION AND DELIVERY CHECKLIST
After the Hale FoamLogix system has been installed the following check list should be used
to verify installation and ensure proper system set-up when apparatus is delivered to the
end user. Use procedures in referenced manual sections.
INSTALLATION
DATE INITIALS
_______ _______ q System properly installed according to installation section of
manual. (SECTION II; START-UP CHECKLIST)
_______ _______ q Tank level sensor function verified for Tank A and Tank B (as
equipped). (SECTION II; SYSTEM INSTALLER START-UP)
_______ _______ q Foam pump operation checked for both Tank A and Tank B (as
equipped). (SECTION II; SYSTEM INSTALLER START-UP)
_______ _______ q Flush indication on control unit display verified. (SECTION II; SYSTEM
INSTALLER START-UP)
_______ _______ q Foam tank(s) and hoses drained of water. (SECTION II; SYSTEM
INSTALLER START-UP)
_______ _______ q Flowsensor function checked and flowsensor calibrated as
necessary. (SECTION III; USER CALIBRATION)
DELIVERY
DATE INITIALS
_______ _______ q Foam tank(s) filled with user specified foam concentrate(s).
(SECTION III; INITIAL END USER SET-UP)
_______ _______ q Foam pump priming checked for both foam concentrate tank(s).
(SECTION III; INITIAL END USER SET-UP)
_______ _______ q Flowsensor calibration verified with pitot. (SECTION III; USER
CALIBRATION)
_______ _______ q Default simulated flow value set to end user specification.
(SECTION III; USER CALIBRATION)
_______ _______ q Default foam concentrate injection rate(s) set to end user
specification for each foam tank (as equipped). (SECTION III; USER
CALIBRATION)
_______ _______ q Foam concentrate feedback values verified and calibrated with
end user specified foam concentrate(s). (SECTION III; USER
CALIBRATION)
_______ _______ q Proper Hale FoamLogix system operation demonstrated to end
user in accordance with manual procedures. (SECTION IV;
OPERATING INSTRUCTIONS)
_______ _______ q End user trained in proper operation of Hale FoamLogix system in
accordance with manual procedures. (SECTION IV; OPERATING
INSTRUCTIONS)
_______ _______ q Warranty registration card filled out by end user and mailed to
Hale Products Inc.
_______ _______ q Two copies of Description, Installation and Operation manual
provided to end user.