User Guide

Remote Control
Note: Both the Halcro Logic UTSR1 and Docking
Station comply with limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful
interference to radio communications. However, this
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment
and receiver
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected
•
Consult the dealer or an experienced radio/TV
technician for help
may void users authority to operate this device”
“Modifications not authorized by the manufacturer
7
B
B
att
att
e
e
r
r
y
y
I
I
n
n
s
s
ta
ta
ll
ll
at
at
i
i
o
o
n
n
an
an
d
d
C
C
har
har
g
g
i
i
n
n
g
g
Your Halcro Logic UTSR1 is supplied with 4 x AAA
NiMH rechargeable batteries, a connector and a
charging adaptor. We recommend you charge your
batteries over night (10 hours) before 1
st
time use.
The battery meter (top-left corner of LCD) will
empty to indicate when the batteries require
recharging.
To install the batteries, open the battery cover; follow
the polarity symbol shown in battery compartment,
place the batteries inside and then replace the cover.
To recharge batteries, put the power adaptor into AC
wall outlet, insert the DC jack to the connector, then
connect to the socket at the bottom of the remote. It
takes approximately 14 to 16 hours to fully charge the
batteries.
Note: The Battery icon is not shown when in
Menu mode.
The unit is designed for optimum operation with
original batteries.
Do NOT connect charging adaptor and connector
when using the non-original batteries.
To avoid data loss, Do NOT attempt remote setup
when batteries are weak.