Installation Guide

CAUTION: The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any

modication or use of non-original components will void the warranty and product liability.

CAUTION: Do not use this equipment for other than intended use.

CAUTION: Do not install in dead air, sheltered, buried or boxed in location. This xture should not be installed in areas

that will entrap heat. It is not intended to be used in potentially dangerous or hazardous locations such as

ammable or explosive atmospheres.

CAUTION: This xture is not for use with UL924 Emergency Lighting Equipment.

Troubleshooting:

1) Check that the line voltage at the xture is correct and the circuit breaker is on. Voltage must be a minimum of

120VAC and no greater than 277VAC.

2) If all the LEDs on the light engine OFF, LED driver may be defective. Using a voltmeter, check to see if

voltage is present at the output of power supply. If low or no voltage, then replace power supply.

3) If any individual LEDs are OFF the LED light engine is defective. Please contact technical support.

4) Ensure that xture is grounded properly.

5) Check for water or moisture in the xture or junction box.

6) If a photocell is used, be sure it is functioning properly.

7) Ensure the photocell is rated for LED loads with minimum load requirement.

Cleaning and Maintenance:

Caution: Do not clean or maintain while the xture is energized. Check that the xture temperature is cool enough to

touch. Periodically check and remove any accumulated dirt or debris from the lens and around xture.

1) Clean glass lens with non-abrasive glass cleaning solution.

2) Do not open the xture to clean the LED. Do not touch the LED.

Replacement Parts:

Contact your sales representative for replacement part availability.

Warranty Information:

This product is warranted for 5 years from the date of purchase, based on 10 hours of use per day.

If this product does not perform to the specications supplied on this package, write to the address below for product

return and replacement. This replacement is the sole remedy available.

Liability for incidental or consequential damage is expressly excluded.

Visit www.halcolighting.com for full warranty details and compatibility information.

All sizes and specications are subject to change.