Installation Guide

1.To prevent personal injury or product damage only licensed electricians should install.
2.To avoid electrical shock or component damage, disconnect power before attempting installation or servicing.
3. All the wires must meet the standard of national installation and the wire junctions must be connected well and
waterproof.
4.Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death,
property damage and/or product malfunction.
5.To prevent product malfunction and/or electrical shock this product must be properly grounded.
Halco Lighting Technologies | 2940 Pacific Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com| Atlanta | Carlstadt | Cleveland | Houston | Los Angeles | Phoenix
© 2018 Halco Lighting Technologies, LLC. All rights reserved. Halco and ProLED are registered trademarks of Halco Lighting Technologies. All sizes and specifications are subject to change. Print Edition 12-18-18.
INSTALLATION
1. Remove luminaire from packaging
2. Remove side screws and adjust
luminaire head up 90 degrees
3. Remove driver compartment screws
and open driver door
4. Using hammer, knockout pre-etched
installation hole for mounting
5. The sponge gasket is pasted to
mounting surface inline with outlet hole.
Connect conduit thru the mounting
hole, bringing the lead into the
luminaire housing. Screw the hole thru
the mounting hole, placing the housing
on the mounting surface, securing with
provided tec screws. Connect wires
(according to wire diagram above).