Installation Guide

ProLED

Direct T8 Installation Instructions

IMPORTANT

READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THESE INSTRUCTIONS FOR FUTURE

REFERENCE.

with the construction and operation of the product and the hazards involved.

These lamps are direct replacements for 32W/48T8, 28W/48T8 lamps only. Operates on Electronic Ballasts only.

WARNING -

luminaires and electrical systems.

WARNING

WARNING dry and damp locations.

WARNING - This device is not intended for use with emergency exits.

Installation steps:

STEP 1: Make sure the power is turned off before removing the existing lamp.

STEP 2:

STEP 3:

STEP 4: Insert ProLED Direct T8 lamp into the lamp holders.

STEP 5: If multiple lamps are required, repeat steps 2-4 as needed for additional lamps.

STEP 6: Close the lens cover and secure into place.

STEP 7: Turn the power back on.

IMPORTANT SAFETY INFORMATION:

CAUTION: f the power,

remove lamp from luminaire and contact the manufacturer.

CAUTION:

This lamp only operates on electronic ballasts. If lamp does not light when the luminaire is energized, remove lamp from

emergency exit lights.

Warranty Information:

This product is warranted for 5 years from the date of purchase, based on 10 hours of use per day. If this product does not

replacement. This replacement is the sole remedy available. Liability for incidental or consequential damage is expressly

excluded. Visit www.halcolighting.com for full warranty details and compatibility information.