Installation Guide
Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone 770.242.3612 | Fax 800.880.0822 | halcolighting.com | Atlanta | Carlstadt | Cleveland | Houston | Los Angeles | Phoenix
© 2017 Halco Lighting Technologies, LLC. All rights reserved. Halco is a registered trademark of Halco Lighting Technologies. All sizes and specications are subject to change. 06-01-17.
5" DOWNLIGHT HOUSING (CAN) (MIN. LAMP COMPARTMENT DIMENSIONS 5"(DIA) x 7.4"(H) for 5 inch):
1. On the back of the downlight, press the two clips towards the center and remove bracket from clips (see g#1).
2. Pull the springs off tab marked “6” (see g#2).
3. Place the springs onto the tab marked “5” (see g#3a). Make sure the angled (slanted) side of the springs faces toward the power supply (see g#3b).
4. Hold the springs, then press the bracket into the clips (see g#4).
5. Once this adjustment is completed, start installation into the downlight housing. Refer to the 6 inch downlight housing directions starting with step 1.
J-BOX (Min Volume:18 in
3
, min Length: 3.25 in, Height: 2.20 in)
1. Before installation, cut the wires of installation harness close to the socket adaptor (see g#1).
2. Next, make 2 pigtail connections. The black j-box wire (hot wire) should be connected to the black pigtail wire of the installation harness. The white
j-box wire (neutral wire) should be connected to the white pigtail wire (see g#2).
3. On the back of the downlight, press the two clips towards the center and remove bracket from clips (see g#3).
4. Pull the springs off of the tab marked ”6”. Discard the springs (see g#4).
5. Fasten the bracket to the j-box. If necessary, use a drill. Note the #6 pointed screws may also be used as a replacement for the bracket screws (see
g#5).
6. The green ground wire that is exposed and attached to the downlight should be cut at the end and the insulation stripped back ½”. Connect ground
wire to the housing.
7. Finally, make the connection between the male (installation harness) and female (downlight) orange connectors (see g#6). Carefully push all
connections into the J-Box.
8. Push the downlight into the J-box, making sure the clips snap into the bracket (see g#7).
9. Downlight should be ush with the ceiling (see g#8).