Instructions / Assembly

ProLED Select Retrot Downlight 6”
Installation Instructions
®
© 2021 Halco Lighting Technologies, LLC. All rights reserved. Halco and ProLED are registered trademarks of Halco Lighting Technologies. All sizes and specications are subject to change. Print Edition 100119
Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com | Atlanta | Cleveland | Houston | Los Angeles | Phoenix
Important:
This product is warranted for 5 years from the date of purchase, based on 10 hours of use per day. If this product does not perform to the specications
supplied on this package, send an email or write to the address below for product return and replacement. This replacement is the sole remedy available.
Liability for incidental or consequential damage is expressly excluded. Visit www.halcolighting.com for full warranty details and compatibility information.
Warranty Information:
This product is warranted for 5 years from the date of purchase, based on 10 hours of use per day. If this product does not perform to the specications
supplied on this package, send an email or write to the address below for product return and replacement. This replacement is the sole remedy available.
Liability for incidental or consequential damage is expressly excluded. Visit www.halcolighting.com for full warranty details and compatibility information.
INSTRUCTIONS
87987 RDL6-10.5-CS-ST
87988 RDL6-14-CS-ST
DIMENSIONAL DRAWINGS
87984 RDL6-10.5-CS-BT
87985 RDL6-14-CS-BT
CCT Selectable
(Fig. 4)
Fig: 4
Fig: 5
(Fig. 2)
Fig: 2
(Fig. 3)
Fig: 3
in. Remove existing trim and CFL, or Incandescent bulbs.
2. Unscrew the screws on socket bracket, push bracket
upward to the top location.
3. Remove existing socket mounting plate from the
recessed housing and then remove lamp socket from
the plate.
4. Screw the E26 adapter into the socket inside the housing.
5. Select desired CCT level using switch on driver box.
(Fig. 5)
Fig: 6
(Fig. 6)
6.
Plug E26 base cable connection into the recessed housing.
(Fig. 7)
Fig: 7
7. Squeeze torsion springs as shown and install into the metal
brackets inside the recessed housing. For proper installation,
the torsion springs should be seated within the brackets and
on both sides of the housing.
(Fig. 8)
Fig: 8
8
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS (cont’d)