Installation Guide

Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com | Atlanta | Chicago | Cleveland | Houston | Los Angeles | Phoenix
© 2017 Halco Lighting Technologies, LLC. All rights reserved. Halco is a registered trademark of Halco Lighting Technologies. All sizes and specications are subject to change. 12-14-17.
INSTALLATION INSTRUCTIONS Continued:
6. Connect the Orange connectors together (see FIG. 4B).
7. Insert torsion springs into luminaire housing brackets (see FIG 5).
8. Gently push up trim and torsion springs so they begin to expand and lift trim in place (see FIG. 6).
INSTALLATION into Existing Recessed LED Luminaire with Compatible orange connectors:
1. Turn OFF Power at switch and fuse box or circuit breaker
2. Remove existing trim installed in recessed housing (if necessary).
3. Discard medium base adapter.
4. Connect the orange connectors together (see FIG. 2A).
5. Insert torsion springs into xture brackets (see FIG. 2B).
6. Gently push up trim and torsion springs so they begin to expand and lift trim in place (see FIG. 3).
Min. Lamp Compartment Dimensions
135mm (53/8 in) DIA X 190mm (71/2 in) HEIGHT When
used in 5 inch recessed Luminaire
Min. Lamp Compartment Dimensions
154mm (6 in) DIA X 188mm (71/2 in) HEIGHT When used
in 6 inch recessed Luminaire
FIG. 4B Connect the orange
connectors
FIG. 1B Diagram of
recessed luminaire
FIG. 6
FIG. 6
FIG. 4A
FIG. 1A
FIG. 5
FIG. 2B
FIG. 2A Connect the orange
connectors
THE RETROFIT KIT IS ACCEPTED AS A COMPONENT
OF LUMINAIRE WHERE THE SUITABILITY OF THE
COMBINATION SHALL BE DETERMINED BY UL OR
AUTHORITIES HAVING JURISDICTION.
Orange
Terminals