Installation Guide

Step 2: Use a screwdriver to remove the screws on the driver box cover and separate the driver box

from the front housing(Figure 3 & Figure 4);

Step 3: Drill an installation holes at the bottom of light, paste the EVA mat(Figure 5 & Figure 6);

Step 4: Drill holes on the wall according to

the locating plate(Figure 7);

Step 5: Fix rubber anchor plugs into drilled holes

(Figure 8);

Step 6: Align the holes on the back housing with the holes on the wall, and tighten the screws(Figure 9);

Step 7: Fasten the front housing to the back housing and connect the wires properly

(Figure 10 & Figure 11);

Step 8: Align front and back housing screws and tighten screws and tighten the screws of the lamp

base (Figure 12 & Figure 13).

Figure 12 Figure 13

4.65″

3.67″

Adjustable Wallpack Adjustable Wallpack