Installation Guide

1. Do not use the electric generator to test the LED lamp;

2. This luminaire must be installed in accordance with your local electrical codes and requirements;

3. Do not install the luminaire in rainy days, to avoid lightning stroke and damage to luminaire.

1. This luminaire must be installed by qualified electrician to avoid electric shock and fire accident;

2. Wear gloves before installation in order to avoid injury;

3. Turn off the power immediately when there is smoke and fire during installation, inform professionals

to overhaul;

4. This luminaire is suitable for outdoor use.

Step 1: Loosen the screws on the side fixture housing with an Allen wrench, and rotate the front housing

to 90 degrees (Figure 1 & Figure 2);

Warning:

Installation notice:

Installation:

L/live wire：Black\Brown;

N/null wire:White\Blue;

Ground wire：Green\Yellow-green.

Note: To meet the requirements of DLC certification, lamps are limited to the same side of

the light-emitting use, not in different directions of illumination use (as shown below)

MIN 90°C SUPPLY CONDUCTORS

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND

OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED

LES FILS D’ALIMENTATION 90 °C MIN

CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT,

PAR UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT

AINSI QUE LES RISQUES INHÉRENTS.

CCT & Wattage adjustment Instruction

1, After the fixture is installed(Step 9), adjust the CCT via a controlling switch as per your

demand, with 3000K/ 4000K/ 5000K optional, as shown in below picture;

2, After the fixture is installed(Step 9), adjust the wattage via a controlling knob as per your

demand, with 3 settings optional, as shown in below picture;

90° 45° 0°

Standard wire:

Warning/Advertisement:

4000K3000K 5000K

Noted：Highest rated wattage and 5000K CCT was setting as default.

Built-in photocell with enable/disable function

Built in

Photocell with

enable/disable

Light angle

adjustable

Adjustable Wallpack Adjustable Wallpack

PAGE 1
Adjustable Wallpack Adjustable Wallpack Standard wire: L/live wire：Black\Brown; N/null wire:White\Blue; Ground wire：Green\Yellow-green. Warning: 1. Do not use the electric generator to test the LED lamp; 2. This luminaire must be installed in accordance with your local electrical codes and requirements; 3. Do not install the luminaire in rainy days, to avoid lightning stroke and damage to luminaire.
PAGE 2
Adjustable Wallpack Adjustable Wallpack Step 2: Use a screwdriver to remove the screws on the driver box cover and separate the driver box from the front housing(Figure 3 & Figure 4); Step 6: Align the holes on the back housing with the holes on the wall, and tighten the screws(Figure 9); Step 3: Drill an installation holes at the bottom of light, paste the EVA mat(Figure 5 & Figure 6); Step 7: Fasten the front housing to the back housing and connect the wires properly (Figure 10 & Figure 11); Step 4: