Installation Guide

ProLED

Volumetric Panel Light Installation Instructions

Take the ProLED Volumetric Panel out of the carton.

IMPORTANT

READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THESE INSTRUCTIONS FOR FUTURE

REFERENCE.

ProLED xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper

grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A QUALIFIED ELECTRICIAN WHO IS FAMILIAR WITH THE

CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING - Risk of re or electric shock. ProLED Panel Light installation requires knowledge of luminaires

and electrical systems. If not qualied, DO NOT attempt installation. Contact a qualied

electrician.

WARNING - Risk of re or electric shock. Suitable for wet locations. Make sure the power is off prior to

installation.

WARNING - Risk of re or electric shock. Suitable for at T-Grid in non-insulated ceilings. Access above ceiling

required. DO NOT cover xture with insulation liner or similar material.

WARNING - DO NOT install in unstable, loose or easily breakable surfaces.

WARNING - DO NOT let objects impact or exert force on the surface of the xture.

Installation Steps:

Open a hole or x the T Bar

on the ceiling.

Warranty Information:

LINE

NEUTRAL

GROUND

White

Neutral

Green

Ground

Black

Line

N White

Neutral Line Connection

Green

Ground Wire Connection

L Black

Live Wire Connection

Thru-wire

Wiring Diagram:

This product is warranted for 10 years from the date of purchase. If this product does not perform to the specications

supplied on this package, send an email or write to the address below for product return and replacement.

This replacement is the sole remedy available. Liability for incidental or consequential damage is expressly excluded.

Visit www.halcolighting.com for full warranty details.

All sizes and specications are subject to change. Print Edition 01-20-17

PAGE 1
ProLED® Volumetric Panel Light Installation Instructions IMPORTANT READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. ProLED fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
PAGE 2
Installation Steps: 3 4 White Neutral NEUTRAL Green Ground GROUND Black Line Remove the access plate. Open up one of the knockouts to allow the power cable into the driver box. 5 LINE Connect the power cable wires to the wiring terminal through the opened knockout. Ensure that the wires have a strong connection. 6 After the power cord is correctly connected, reinstall the access plate. Verify that the LED light works prior to installing into the ceiling.