Operation Manual

05-7175-00-00.fm 69
Maintenance and Servicing
Height adjustment
The height adjustment (X) of the supporting rollers Fig. 34-F has been set to
3 mm in the factory. If striping still occurs despite optimum inclination adjust-
ment, set the distance of the supporting rollers to the lower edge of the sealing
strip by adjusting the number of washers under the supporting roller holder.
Number of washers /
Distance to the
ground (X)
Use
1/2mm Very smooth floor surfaces, e.g. coated screed,
PVC, linoleum
2/3mm Standard setting
3/4mm Very uneven floor surfaces, e.g. poorly laid tiles
(water does not drain off)
Fig. 34:
F
X
2 mm
3 mm
4 mm