Phau Ntawv Qhia

EN DE
33
3.2.3. Anschluss des Ofens an einen Harvia-Edel-
stahlschornstein
Zur Abführung der Verbrennungsgase kann ein CE-
geprüfter Harvia-Stahlschornstein verwendet wer-
den. Die Ofenrohre sind aus rostfreiem Stahl gefer-
tigt, und der Schornstein wurde feuerfest isoliert.
Der Schornstein hat ein rundes Prol. Das Ofenrohr
misst 115 mm im Durchmesser und der Außenman-
tel 220 mm. Siehe Abbildung 11.
1. Öffnen Sie den Deckel der hinteren Anschluss-
öffnung (nur M1/M2/M3, Classic 140/220/280,
Premium/Premium VS, Linear 16, 16). Verbie-
gen Sie die Halterung mit einem Schraubendre-
her.
2. Versetzen Sie den Stopfen von der oberen
Anschlussöffnung auf die hintere Anschlussöff-
nung.
3. Verbiegen Sie die Halterung mit einem Schrau-
bendreher. Klappen Sie den Deckel zurück nach
oben und befestigen Sie ihn mit einer Schraube
(nur M1/M2/M3, Classic 140/220/280, Pre-
mium/Premium VS, Linear 16, 16).
4. Schließen Sie das Ofenrohr des Stahlschorn-
steins an die obere Anschlussöffnung des
Ofens an. Vergewissern Sie sich, dass das
Ofenrohr fest an seinem Platz sitzt. Genauere
Anweisungen nden Sie in den Installationsan-
weisungen des Stahlschornsteins!
Bei Verwendung eines Schutzmantels um den
Ofen herum muss der isolierte Teil des Rauch-
fangs auf Höhe der Oberkante des Schutzmantels
oder darunter anfangen.
3.2.3. Connecting the Stove to a Harvia Steel Chimney
A CE-marked Harvia steel chimney can be used
to remove combustion gases. Its smoke pipes are
made of stainless steel and the chimney has been
insulated for re safety. The chimney has a round
cross section. The smoke pipe diameter is 115 mm,
and the outer casing is 220 mm. See gure 11.
1. Open the cover hatch of the rear connection
opening (M1/M2/M3, Classic 140/220/280,
Premium/Premium VS, Linear 16, 16 only).
Bend the holder with a screwdriver.
2. Move the blocking plug from the upper
connection opening on the rear connection
opening.
3. Bend the holder with a screwdriver. Turn
the cover hatch back up and lock it in its
position with a screw (M1/M2/M3, Classic
140/220/280, Premium/Premium VS, Linear
16, 16 only).
4. Connect the steel chimney’s smoke pipe to the
upper connection opening of the stove. Ensure
that the smoke pipe ts tightly in place. See
the detailed instructions in the steel chimney’s
installation instructions!
If a protective cover is used around the stove,
the insulation of the chimney must start from
the same level as the top surface of the protective
cover or underneath it.