Phau Ntawv Qhia
FIGURE 3: BOARD CARRIER
FIGURE 4: LENS
FIGURE 2: TETHER
CAUTION:
This fixture is designed for permanent installation in ordinary (Non-Hazardous) locations in accordance with the National Electrical Code and
all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and fixture operate at high temperatures.
Contact with combustible materials can cause fire and personal contact can cause severe burns.
FLUXSTREAM LED STRIP
Page 1 of 4
INSTALLATION INSTRUCTIONS
CAUTION: THE INSTALLATION AND SERVICING OF
THIS PRODUCT SHOULD BE PERFORMED BY A
QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
MOUNTING BRACKETS
CABLE MOUNT ASSY
(PURCHASED SEPARATELY)
HOUSING REVEAL
SURFACE MOUNT SCREWS
V-HOOK ASSY
(PURCHASED
SEPARATELY)
STEM MOUNT KO
KO FOR
WIRING ACCESS
KOs FOR
WIRING ACCESS
FIG. 1- STAND ALONE CONFIGURATION
1) Remove unit from carton and inspect to ensure no shipping damage has occurred.
2) This luminaire is supplied with knockout holes for wiring access across the back of housing and side of each end cap.
3) To install with HANGER BRACKETS (See FIG.1):
A. Mount hanger brackets to structure with #8 screws. (Minimum 2 brackets per luminaire)
B. Once mounting brackets are secured to surface, snap luminaire into brackets. Mounting bracket should be secured into reveal of
luminaire. Tighten mounting bracket with #8-18 x 2" bolt that is provided.
C. Secure LED board to housing by looping tether over "T" lance as shown in Figure 2.
D. For
stand alone installation bring customer supply wires into luminaire though preferred knockout hole. Make electrical
connection per electrical code.
E. For
continuous row mounting refer to "CONNECTING LUMINAIRES FOR ROW MOUNTING": follow steps A, B and C
above for each luminaire. A customer supplied chase nipple and lock nut should be inserted into the knockout hole on each end of the
adjoining fixtures as shown in Fig 6.
4) To install with optional chain/hanger kit (PURCHASED SEPARATELY): Remove the V-Hook and chains from the bag pack.
Hook the V-Hook into each end of the luminaire in provided holes. The chains should then be attached to the permanent structure of
the building.
5) To install with cable/stem mounting assembly (PURCHASED SEPARATELY):
A. Mount cable or stem to building structure above luminaire.
B. Remove stem mount KOs shown in Fig 1 at each end of fixture
C. Mount cable or stem to fixture in KO hole using included hardware.
6) Snap on LED board carrier by aligning screws in LED board carrier with notches in housing. Then pivot board carrier until opposite
side snaps in as shown in Fig 3, making sure no wires are pinched between housing and board carrier.
7) Snap on lens by angling one side in and then pivot the opposite end around to snap in the other side as shown in Fig 4.
12NC: 44210
201
(ENGLISH)