User manual

ManualsBrandsHaima ManualsOther7

Abbreviation

GI-4

Abbreviations

A/C Air conditioner

ABDC After bottom dead center

ABS Anti-lock brake system

ACC Accessory

ATDC After top dead center

ATF Automatic transmission fluid

ATX Automatic transmission

BBDC Before bottom dead center

BTDC Before top dead center

CM Control module

DSC Dynamic stability control

GPS Global positioning system

EX Exhaust

HI High

HU ASB hydraulic unit

IG Ignition

IN Air intake

LCD Liquid crystal display

LED Lighting electric dioxide

LF Front left

LH Left hand

L.H.D. Left hand driving

LO Low

LR Rear left

M Motor

MAX Maximum

MTX Manual transmission

O/D Over-speed driving

OFF Shut off

ON Turned on

PCM Power control module

P/S Power steering

P/W CM Power window control module

RDS Radio data system

REC Recycling

RF Front right

RH Right hand

R.H.D. Right hand driving

RR Rear right

SAS Safety airbag system

SST Special service tool

SW Switch

TCS Traction control system

TFT Thin film semiconductor

TNS Tail lamp and side turn lamp

1GR Gear 1

2GR Gear 2

Summary of content (3 pages)

PAGE 1
Abbreviation Abbreviations A/C Air conditioner M Motor ABDC After bottom dead center MAX Maximum ABS Anti-lock brake system MTX Manual transmission ACC Accessory O/D Over-speed driving ATDC After top dead center OFF Shut off ATF Automatic transmission fluid ON Turned on ATX Automatic transmission PCM Power control module BBDC Before bottom dead center P/S Power steering BTDC Before top dead center P/W CM Power window control module CM Control module RDS Radio data sys
PAGE 2
Regular Maintenance Regular Maintenance Since ignition and fuel system are essential to emission and high performance of engine and related system, it is strongly recommended that these systems should be serviced at Mazda appointed maintenance stations. After recommended period, conduct inspection for regular maintenance items periodically. For items with * mark, pay attention to following: 1: If any devices adjusted, inspect power steering and AC drive belt.
PAGE 3
Regular Maintenance Symbol Description: △＝ Inspect, and clean, adjust or replace if necessary ▲＝Replace; ◎＝Items needed to be tightened to the specified torque Maintenanc e Interval Items Maintenance interval is based on readings of odometer or numbers of month (whichever comes first ) Months 6 1 2 18 2 4 30 3 6 42 4 8 54 6 0 66 7 2 78 84 ×1000k m 7. 5 1 5 22.5 3 0 37. 5 4 5 52. 5 6 0 67. 5 7 5 82. 5 9 0 97.