Installation and User Manual

16 49-1000469 Rev. 3
ENGLISH
INSTALLATION INSTRUCTIONS
INSTALLING THE REFRIGERATOR -
FREEZER DRAWER (Cont.)
(on some models)
D. Lower the front end of the freezer drawer assembly
öò÷ëèöìçè÷äåöĤ÷ìñ÷ò÷ëèéõòñ÷öïò÷öòñ÷ëèõäìï
assemblies.
E. Replace the safety screws in both sides of the slide
assemblies.
F. Replace lower and upper baskets (see Freezer Drawer).
REFRIGERATOR SUGGESTED ASSEMBLY
Shelves shown in the location for best energy efficiency.
CONNECTING TO THE HOUSE WATER
LINE
NOTES:
• Before making the connection to the refrigerator, be sure
the refrigerator power cord is not plugged into the wall
outlet.
• Before connecting the water line to the house, purge the
house line for at least 2 minutes.
• Some models have the refrigerator connection at the
water valve¤ÌòñĤêøõä÷ìòñ!¥Other models have the
refrigerator connection at the end of tubing located
outside the compressor compartment access cover
¤ÌòñĤêøõä÷ìòñ"¥
¬ ØñÌòñĤêøõä÷ìòñ!Öòçèïö÷ëè
refrigeration connection is at the water
ùäïùèõèðòùè÷ëèóïäö÷ìæĥèûìåïèæäóäö
shown here.
Water supply connection.
If you are using copper tubing, place a compression nut and
ferrule (sleeve) onto the end of the tubing coming from the
house cold water supply.
If you are using Universal water line tubing, the nuts are
already assembled to the tubing.
Refrigerator Connection.
If you are using copper tubing, insert the end of the
tubing into the refrigerator connection, at the back of the
refrigerator, as far as possible. While holding the tubing,
÷ìêë÷èñ÷ëèĤ÷÷ìñê
If you are using Universal water line tubing, insert the
molded end of the tubing into the refrigerator connection, at
the back of the refrigerator, and tighten the compression nut
until it is hand tight. Then tighten one additional turn with a
wrench. Overtightening may cause leaks.
QNE27J
27 cuft. Models
French Door with Freezer Drawer
WARNING
Connect to potable water supply only.
A cold water supply is required for
automatic icemaker operation. The water pressure must
be between 40 and 120 psi (275-827 kilopascals).
WARNING
ELECTRIC SHOCK HAZARD
Attach tubing clamp using existing hole only. DO NOT drill
into the refrigerator.