Service Guide

18
9.4 Maintenance
* Only when the air cleaner is switched off and disconnected to the power supply can it be cleaned, or electric shock
and injury may appear.
Cleaning the air outlet port and the shell:
Cleaning Air Cleaner:
• Do not use gasoline, benzene, diluents, polishing powder or liquid insecticide to clean them.
• Do not clean them with hot water of over 122°F(50°C) to avoid fading or distorting.
• Don't rinse the air cleaner with hot water of above 122°F(50°C) to avoid fading and distorting.
• Don't put the air cleaner on the re to dry to avoid catching re.
Attention
Attention
• Wipe them with soft dry cloth.
• Water or neutral dry cleanser is recommended if the dust cannot be removed.
• The Wind Deector can be dismantled to clean (as below).
• Wipe dust with water or dust collector.
(A) Wipe dust with dust collector.
• (B) Clean it with soft bush in mild detergent
if there is too much dust on it
Throw off the water and airing it in the
cool dry condition.
Cleaning Wind Deector:
Maintenance before and after Operating Season
• Do not wipe the wind deector with water forcibly to avoid falling off.
Before Operating Season:
1. Please make the following checkup. If abnormal condition occurs, consult the after-service personnel.
There is no blockage in inlet port and outlet port of outdoor and indoor units.
The ground line and the wiring are in the proper state
2. After cleaning, the air cleaner must be mounted.
3. Switch on to the power.
After Operating Season:
1. In sunny days, blowing operation can be performed for half a day to make the inside of machine dry.
2. Electrical power should be cut down to economize electricity, or the machine will still consume power.Air
cleaner and shell must be mounted after cleaning.