Owners Manual

49-5000255 13
ENGLISH
INSTALLATION INSTRUCTIONS
3. Installation of Connection Kit
Use parts and components specified for installing the installation components.
A. Change the installation direction of electric box according to requirements following the steps below.
1. Remove the cover of the electrical appliance box; (2 screws)
2. Remove the top plate; (2 screws)
3. Remove the electrical appliance box; (2 screws)
4. Change the outgoing direction of wiring (electric valve coil) between the equipment and the electrical appliance box.
5. Rotate 180° to install the top plate;
6. Install the electrical appliance box;
7. Install the cover of the electrical appliance box.
Install the lifting tools on the lifting bolts according to the instruction below. Be sure to follow the stipulations on products
locally purchased to use nuts (M8 or M10 of 3 pieces for 4 positions) and gaskets (M8 with the outer diameter of 1” to
1-1/8” and M10 with that of 1-1/8” to 1-5/16” of 2 pieces for 4 positions) on the upper and lower sides of the lifting tools.
NOTES:
• Be sure that the product must be installed with the top surface (the oblique surface in the figure below) upward, or it
will not work well and increase the working noise.
④
Electrical appliance removal
①
①
③
②⑥
②⑥
③
⑤
⑤
⑦
⑦
Wall mounted
Gasket
(purchased locally)
Double nuts
(purchased locally)
Lifting bolt
(purchased locally)
Nut
(purchased locally)
Connection kit
10-15mm
Lifting tool
Lifting bolt
(purchased locally)
Double nuts
(purchased locally)
Gasket
(purchased locally)
7/16” to 9/16”
Connection kit
Ceiling mounted