Operation Manual

Getting Started
EN-10 LED Backlit Flat TV Instruction Manual
NoteNote
• During the initial setup, if the TV is powered off before
a password is set, a new password must be set from the
Lock menu. Enter the default password-1234 to access
the Lock menu, then change the password. See
“Change Password” on page 17 for more information.
6. Press S/T to highlight your tuner mode, then
press X to continue.
7. Press S/T to highlight Scan, then press X to start
the channel scan.
If the tuner mode is Cable, press S/T/W/X and
number buttons to configure the cable
information, then press OK to start the channel
scan.
8. Wait a while for the channel scan to complete.
9. When the channel scan is completed, press OK to
exit the wizard.
NoteNote
• The initial setup process may vary depending on the
country you select. Follow the on-screen instructions
to complete the setup.
Initial Setup Tuner Mode
Please select your tuner mode:
Back Select Next
Cable
Antenna
Initial Setup Channel Scan
First, please connect antenna.
Start channel scan now?
If you skip this step, the channel scan could be performed in Menu.
Back Select Next
Skip Scan
Scan
Initial Setup
Please configure the cable info.
Select Next
Symbol Rate (Ksym/s)
Frequency (KHz)
Modulation Auto
Network ID
Scan Mode Advance
Auto
Auto
306000
Initial Setup Channel Scan
The channel scan may take a while to complete.
21%
Status: Scanning...
Analogue Channels: 0
Digital Channels: 0
Initial Setup Complete
Congratulations!!
Completed Initial Setup.
Please press [OK] to exit the wizard.
Back