User Manual

and wall should be at least 20mm
Set the desired washing program,after setting, press the “Start/Pause” button,and
washing machine begin to run. Then hold the “Progress” button and “Delay” button at
the same time for more than 3 seconds，you will hear three beep sound，digital tube
display “CL”,and the child lock will activate. All of the buttons are locked, and will no
function.
the
“Progress” button and “Delay” button
at the same time for more than 3 seconds,
Child Lock
the child Lock
the child lockafter three beep
The energy test program was performed using the "Cotton" cycle
setting of:
Soak:30 mins; Water Temp:Warm; Rinse: 1 Rinse;Spin:7 mins
Water level:Max.
Please use low suds/high efficiency detergent.
Note:
This washer has a 2-step water fill to achieve the required water level and temperature
for the best cleaning result.
First Fill - Once options and cycle are selected and the
Start/Pause Button is pressed,
both hot and cold water will flow into the inner tub. The warm water temperature helps
to dissolve detergent quickly. The washing operation starts at the end of the hot water
fill and is followed by a 5-minute (approximately) soak-agitation session to help the
detergent mix completely with the laundry.
Second Fill - The second fill is in order to reach the selected water level and make
the clothes completely soaked in water to achieve a better wash effect.
To disable the child lock function:
used，
，close the lid and press the “start/pause”,the machine will run
“ ”
If you choose the Cotton program, it is not suggested to put the
softener, because the softener can not be put in the inner tub