User Manual

Remove
Lint filter:
The lint filter must be used during washing.
It must be cleaned in time after each using.
Figure 1
Figure 2
Clean the detergent box and set it on the
control panel seat.
1.Dismantle: Pull the detergent box, then hold
two sides with hands.Press downwards and
pull meanwhile, then it can be pulled out.
.
1.Push down the spring piece of the top lint filter to
make the claws out of the filter cover, and then pull
out the lint filter to get it down.( figure 1)
2.Pull the back of the lint filter, and then you can get
down it off the front cover of the lint filter.(figure 2)
3.Sweep the lint in the lint filter.
4.Put the back of the lint filter into the front cover .
5.Put the lint filter into filter cover, and make it tight.
6.Make sure the lint filter well installed, or it can
influence your use.
The front cover of the lint filter
The back cover of the lint filter
Up
Install
Dismantle
Down
Up
Down
Install
Dismantle
3.Install : Install it upwards and push it in.
2.Clean: Use a brush and duster cloth to clean
it, then flush it with water.
The applicance water pressure is 0.03MPa-1.0MPa
(when water temperature is 55℃,the water inlet
pressure of hot water shall not exceed 0.4MPa).
℃
The new hose-sets supplied with the appliance
are to be used and that old hose-sets should
not be reused.
The maximum mass of dry cloth to be used in the
appliance is 10kg for HWT10MW2.
This product has been designed for use in a normal
domestic (residential) environment.
This product is not designed for any commercial use
(whatsoever). Any commercial use by a customer will
affect this product’s Manufacturer’s Warranty.