Spin-dryer This manual is for HWS60-40 HWS60-50 Please read this manual carefully before using. Retain it for future reference.
Contents Pcking list The 2nd cover Specification Names of the parts The 2nd cover Safety precautions The musts in using Using sequence Trouble-Shooting *Answers to question Packing list ×°Ïä˵Ã÷ Name Quantity User's manual One piece Warranty card One piece Water inlet hose One piece Gland One piece Spin-drier One set Specification Injection pressure(MPa) 0.02 0.2 Rated spinning capacity kg 6.
Names of the parts Cover of the spin tub Knob of spin timer Inner cover Water-filling entrance Panel support Control panel Power line Handle Spin tub Drain hose Cabinet Base frame Back cover Fixing leg (four pieces) Note:The figures in this manual can only be regarded as diagrammatic sketches. Please understand that, due to constant improvement of design, the extractor and its accessories that you have purchased may be inconsistent with these figures in the manual.
Safety precautions Please insert the power cord into special receptacle with rated voltage.Be sure to use single-phase three pins receptacle.If possible,please adopt electric leakage protector. When the machine is normally using, please put the power plug at the location easily to be inserted and extracted by hand. Be sure to pull the plug off when there's power failure, or the machine is being moved, cleaned or when it is idle. Do not bend, stretch, twist, bind the power cord by force, or reform it.
Safety precautions Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine. Do not decompose, repair or alter the machine by yourself. Do not wash laundries with volatile materials (such as thinner, petrol etc.). l Petro Handicapped or children without care shall not use the machine.
The musts in using Usage of the panel OFF OFF 5 1 10 2 4 2 8 4 3 WATER INLET Water-added rinsingspinning,to be used during defoaming -spinning. SPIN TIMER Set the spinning duration depending on the category and amount of the articles. To set to below 1 minute, first set to 2 minute then turn it back. it can increase the service life of the timer HWS60-40 6 SPIN TIMER Set the spinning duration depending on the category and amount of the articles.
Spin process 1 Put the laundries in properly 2 Put the gland in properly 3 Close the inner and outer cover of the spin tub 4 Do you need water-added Rinsing-spinnning Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt, It works in a way as follows: Spin Foam-removing spinning Spin for about 1~2 minutes Remove most of the foam extra detergent liquid.
Disposal after spinning 1 2 3 4 Hang up the drain hose. Pull off the power plug and hang up the power cord. Wipe the complete unit with soft cloth twisted dry. Open the inner/outer cover of the spin tub for some time (about one hour), then close them. Maintenance 1 Wipe off the water drops on the surface and inside the tub with clean soft cloth. 2 Be sure to pull off the power If the cabinet is dirty, wipe it with wet soft cloth Do not wash it directly by water.
