Fully Automatic Washing Machine User's manual This manual is for HWM6802 Please read this manual carefully before using. Retain it for future reference.
Contents Specifications.....................................................................................the 2nd cover Names of the parts................................................................................................1 Safety precautions .............................................................................................2 Installation and adjustment ...................................................................................4 Preparation before washing ....................
Packing list Name User's manual Quantity One Storage position Inside the document bag Top lid A Top lid B Guarantee One Control panel Components of the water inlet hose Filter cover One Notice label Inside the accessory bag jointer connecting the water inlet hose and the water faucet Detergent box Hanging hole for the drain hose Inner tub Handle Pulsator the end connecting to the water inlet hose jointer Control panel film Bottom plate One Between the upper cushion of the washing machine pa
Safety precautions Please plug the plug on special 220-240V AC receptacle.Be sure to use single-phase three pins receptacle.Ensurethe earthing prong of the power receptacle is earthed reliably.Use leakage protector if possible. The power cord plug should be convenient to be pluged in or pluged out with hand while the washing machine runs normally. Be sure to pull the plug out and close the water tap when the machine is idle,when moving the machine,or when cleaning the machine.
Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children.Do not let the children climb the washing machine. Do not decompose, repair or alter the machine by yourself.
Installation and adjustment 3 Press the "WATER LEVEL" button to select suitable water level Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the bottom plate WATER LEVEL After switching on the power, press the button "WATER LEVEL" to select a water level according to the load. Please refer to the button " Water level" on page 10.
Install the water inlet hose Confirm the water tap Water tap,suitable Use the operation buttons Water tap,not suitable b. Operating procedure and explanations for the buttons Outlet end surface >10mm PROGRAM It is required that the front end shall be longer than 10mm. The outlet end surface of the tap shall be flat and smooth. If not please file it to avoid leakage.
Use the operation buttons Connection between the water inlet hose and the washing machine a. Description of the function of the buttons 1.Do not take off the water absorption Nut of the water inlet hose cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately. 2.Put the nut of the water inlet hose on the valve jointer. 3.Fasten the nut. Swaying it gently to Water absorption cushion confirm if it's suitable.
Put in the laundries Preparation before washing Preparation before washing 1.Connect the water inlet hose and open the water tap . 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put down the drain hose. Pay attention to followings before washing the laundries Confirm if there's special requirment for the laundries. Clear the pocket. Take out the coins , sand, hairpins etc.
