User Manual

6
In on
Dismantle the transport
on bolts
The transpo
on bolts are designed for clamping an -
vib
on components inside of the washing machine during
the transpo
on process.
Remove the back cover.
Remove the four bolts on the rear side and take out
Replace the back cover.
Fill the holes le
by the bolts with blanking plugs.
Note:
When you replace the back cover, the convex
must face to outside, and you have to insert the
back cover from the two gaps as sho !"#!"$%&'&"
Keep the transporta on bo
stabilizers in a safe place for later use.
Before Use
5.
(&)*+",- !"+./"012.#!/"3124 15,67"8/0-9/"+./":-*5"625/ 6";$%*5/"(&<
upright.
1.
3.
2.
They are used for
There are adjustable feet under the bo om of the washing machine. Before
use, they should be adjusted so that the machine is level. This will minimize
vibr
ons and thus noise during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment.Floor should be as stable and
=1+"16">-66#3?/&
1. @--6/"+./"?-24"!*+";A<"3B"*6#!%"1" 5/!2.&
2. C,D*6+"+./".#%."3B"+*5!#!%"+./":--+";(<&
3. E#%.+/!"+./"?-24"!*+";A<"1%1#!6+"+./".-*6#!%&
Adjus ng the feet and locking nut