Installation Guide

14
English
You need to drill holes for the top support
screws, a hole large enough for the power
cord to fit through, and a cutout large
enough for the exhaust adaptor.
• Read the instructions on the TOP
CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions
on the TOP CABINET TEMPLATE.
CAUTION:
Wear safety goggles when drilling holes in the cabinet bottom.
Place the microwave in its upright 1.
position,with the top of the unit facing up.
Remove the screw that holds the blower
plate to the microwave. Remove and
save the screw holding the blower motor
to the microwave.
Carefully pull out the blower unit. The 2.
wires will extend far enough to allow
you to adjust the blower unit.
Roll the blower unit 90° so that fan 3.
blade openings are facing out the top
of the microwave.
A2. USE TOP CABINET TEMPLATE FOR PREPARATION OF
TOP CABINET
A3. ADAPTING MICROWAVE BLOWER FOR OUTSIDE
TOP EXHAUST
Blower Plate
Blower Motor
Screw
Back of
Microwave
End B
End A
Back of
Microwave
Back of
Microwave
Before Rotation After Rotation
Back of
Microwave