USER MANUAL HLT71 7'' DIGITAL LCD TV IMPORTANT READ THESE INSTRUCTIONS BEFORE USE AND RETAIN FOR FUTURE REFERENCE.
IMPORTANT SAFETY INSTRUCTIONS SAFETY INFORMATION 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacture's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)that produce heat.
Controls WARNINGS: This TV monitor should be operated only at the adaptor supplied. Do not try to repair the TV monitor yourself as it contains no user-serviceable parts. The TV monitor should only be repaired by a qualified technician. Stop using the TV monitor if the cabinet is damaged. Have it checked by a service technician. Put your monitor only in a clean, dry environment. Unplug the monitor immediately if it gets wet, and consult your service technician.
Remote control operation 10 PICTURE MTS ZOOM MENU SLEEP EPG 11 EXIT TV/AV 1 2 4 5 6 7 8 9 14 16 CH+ 17 CH- 9 ATTENTION: Do not rotate the antenna in counter direction after fixing, it may get loose & effect the channel reception. 15 3 INFO 8 12 13 ENTER 6 7 Directly connect external movable antenna to RF in, may also connect roof antenna directly. For better reception: Adjust the direction/position of the antenna. The signal strength depends on the area of reception.
Note: this ATSC&Analog TV receiver can store the channels from 2~69, and the maximum of each channel has 8 programs. To select the desired programs by using - button and numeric buttons. Do as follows: To select CH 13 NO. 2 Press 1 and 3, then press - and input 2. Once the input is done, it will start broadcasting the selected channel immediately.
Connecting to the DVD/VCD AV terminals To power outlet To video input connector (yellow) To audio input connectors (red, white) Video/audio cable AC power cord Video L R Symptom Remedy / Possible of causes No picture and sound Check the power supply. Check the power switch and make sure it is at the ON position. No picture Make sure the channel is properly selected. External antenna is used for poor reception area.
Warranty This Haier brand product, when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective product with a new or re-manufactured equivalent at no change to the purchaser, for parts or labor for the periods set forth below: Responsibility of Haier to the purchaser with respect to the product, and shall constitute full satisfaction of all claims, whether based on contract, negligen
Haier HLT71
