If you have any questions please contact Ithe Customer Care Department as indicated on the warranty card
Water dispenser
purchasing a please ensure the safe symbols are observed: 35
water filter 36
Safety Precautions number Place 6 34
33
31
away from high 32
30
Assembly of the Door Handle Please follow the instructions below when assembling the Refrigerator Door Handle: removing please follow the instructions in reverse. Attention: Please do not disassemble the Refrigerator door handle. If the handle must be taken apart please contact a qualified technician.
Please follow the instructions below when assembling the Freezer Door Handle: Please do not disassemble the Freezer door handle. If the handle must be taken apart please contact a qualified technician. ԡ See page 12 for instructions on how to connect the water.
Assembling the water connection Removing and replacing the freezer drawer and ice bin For water dispenser product only Contents of filter kit 1 4 m (13 ft) white 6 mm ( ”) tubing 2 1 x 200 mm (8”) blue tubing filter 3 1 x pressure reducing valve (PRV) 4 1 x double sided foam 5 2 x locking keys 6 1 x water filter cartridge and head 7 1 x tap connection – 15 mm ( ”) BSP Removing and Replacing FreezerDrawer 1 2 3 4 5 6 7 Fig.
18. 19. • • • • • • The first time you require water out of the dispenser, there will be a delay while the water reservoir fills up. Run a further 3 litres (3 qt) through the system, stopping intermittently to ensure the reservoir is flushed out. Failure to do this will result in excessive dripping from your dispenser. Important! All connections must be checked for leaks. If unsure of connection process and/or leaks then contact your local plumber to install and check the system for you.
First Use gWhen preessing the water dispenser tab the first time you may not get water out as air will be in the g 11. 12. Please throw away the first 5 cups of water to remove any impurities in the lines. gIf you like very cold water first add some ice cubes from the ice storage box. Do not put hands or other items into the water dispenser or ice storage box. 13. 14. 15. Attach double sided foam to the back of the water filter head as shown in Diagram 5.
Installation instructions: 3. 4. 5. 6. 7. 8. 9. 10. • • • • Diagram 1 Fig.2 PRV connection Diagram 2 Fig.3 Waterline connection to refrigerator have an Diagram 3 Fig.4 Tap connection ET 2. Ensure that refrigerator is not plugged into a power supply. Locate isolation tap for water connection – cold water feed only (dishwasher or sink mixer taps) – if you can’t find the connection tap, contact an authorised plumber in your state or town to fit your water connection.
9 7 Adjustment 9 To ensure normal operation,allow the appliance to stand still for 6 hours.
Control panel
