Use and Care Manual

DEHUMIDIFIER USE
IMPORTANT: If the dehumidier has been tilted on its
side, wait 24 hours before turning on the dehumidier to
allow the oil to return to the compressor. This will
prevent the dehumidier from failing prematurely.
Allow 20" (51 cm) of space around the unit for proper air
circulation.
Do Not operate the dehumidier without an air lter in
place.
Do not spill liquid on the control panel; it may cause an
electrical short to the interior electronic parts that would
either disable them or cause them to function
improperly.
When the unit is operated in high humidity conditions,
you may need to empty the water bucket more
frequently.
When the water collection bucket is full, the dehumidier
will stop operating automatically. The Bucket Full
indicator illuminates to alert you of this condition. Empty
the water collection bucket. See “Cleaning.”
When the empty water collection bucket is replaced
properly, the dehumidier will restart and operate
normally.
DEFROST MODE
If the dehumidier is operated at temperatures below
54°F (12°C), but above 41°F (5°C), the surface of the
evaporator may accumulate a layer of frost which would
reduce the eciency of the dehumidier. So, the
dehumidier will enter periodic defrost mode. The time
to defrost may vary. If the dehumidier freezes up, turn it
o at the power supply and restart.
NOTE: If the room temperature remains below 41°F
(5°C), the dehumidier should be turned OFF.
DEHUMIDIFIER CARE
WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Failure to do so can result in death or electrical shock.
CLEANING
1. Unplug dehumidier or disconnect power.
2. Use only a soft cloth dampened with water to clean the
cabinet.
NOTE:
Do not use a liquid or spray cleaner to clean the
dehumidier.
Do not wash with a hose or immerse in water.
DO NOT use chemicals, abrasives, ammonia,
chlorine bleach, concentrated detergents,
solvents or scouring pads. Some of these
chemicals/items may damage and/or discolor
your
dehumidier.
3. Wipe dry with a soft cloth.
4. Plug in or reconnect power.
AIR FILTERS
Your dehumidier features a removable air lter located at
the back of the unit behind the humid air intake grille.
IMPORTANT:
DO NOT use your dehumidier without
the air lter in place.
1. Unplug or disconnect power.
2. Pull on the tabs to slide out the lters from the back of
the dehumidier.
NOTE: The secondary lters are accessible once
the main lters are removed.
b
a
A
Air Filter
B
Humid Air
Intake Grille
3. Wash or vacuum the dust from the air lters.
NOTE: If washed, gently shake the lter to remove
the excess water and dust particles trapped in the
lter.
4. Reinstall the lters.
5. Plug in or reconnect power.
7
ENGLISH